CAPTURING WHAT CAN NOT BE SEEN
Mold and Fungi Bulk Sampling
(800) 567-7729
Penicillium: Related to Peritonitis,
Keratitis, Infection Agent and may cause Systemic Disease in
Immunocompromisied Hosts
| Non-Viable Samples: Wipe, tape lift, dust, air, soil or vac samples that are analyzed to determine the presence and concentration of non-specific mold spores. Data from Non-Viable samples does not provide insight on the type of mold present or its toxicity. |
| Viable Samples: Mold samples taken with the intent to incubate and grow the captured mold in a laboratory environment in order to define the species of mold, its concentration and its potential toxicity. |
The Mold Samplers will hunt down visible and invisible mold in your house or building and perform bulk sampling to determine if there is a problem. We may use any combination of the following different types of mold bulk sampling techniques depending upon the situation:
BULK SAMPLES: A piece of the substrate is taken with the suspect mold intact. The sample is sealed in a plastic bag and sent to one of our third party analytical laboratories for analysis for mold spores. This test provides good data on the presence or absence of mold on a surface.
WIPE SAMPLES: A surface suspected of having mold growth is wiped with a pre-moistened cotton swab. The swab is placed in a sealed tube with a liquid solution and sent to one of our third party analytical laboratories for analysis for mold spores. This test provides good data on the presence or absence of mold on a surface and is often used for post removal testing.
DUST SAMPLES: Dust can be collected using a variety of methods and placed in a sealed bag and sent to one of our third party analytical laboratories for analysis for mold spores. This test provides good data on the presence or absence of mold disseminated throughout a home or office.
SOIL SAMPLES: Mold can be found in the crawlspaces of homes and buildings. Soil is collected in glass jars and sealed air tight. The jars are sent to one of our third party analytical laboratories for analysis for mold spores. This test provides data on the presence or absence of mold is soil.
TAPE LIFT: A surface with visible mold growth is sampled with a strip of clear sticky tape. The tape is placed over the mold affected area and pressed down to stick the sample to the tape. The tape is placed on a clean glass microscope slide, sealed in a plastic container and sent to one of our third party analytical laboratories for analysis for mold spores. Test results allow us to make estimates on the concentration of mold spores on a given surface area.
VAC SAMPLES: Carpet can often be a breeding ground for mold. A cassette with a micro cellulose ester filter is connected to a high-flow air sampling pump. A one-square foot area of carpeting is vacuumed with the sample cassette. Dust and mold spores found deep in the carpet are sucked into the sample cassette. The cassette is sealed airtight and sent to one of our third party analytical laboratories for analysis for mold spores. This test provides good data on the presence or absence of mold and gives a rough idea of concentrations in areas with carpeting.
